Replacement lamp for Sidel SBO 20 Series 2

Wed, 08 Jul 2026 22:25:31 +0800

Replacing Sidel SBO 20 Series 2 Heaters: The Real Story Behind the Power

Let’s be honest—running a smaller PET line doesn’t leave room for guesswork. When you’re ready to upgrade an older Sidel SBO 20 Series 2 blow molder, it often starts with the one part that does the heavy lifting: the infrared heating lamp. We built our replacement as a straight-up, plug-and-play upgrade. So you can swap out the old heater without rewiring the whole oven. Seriously. No headaches.

Sidel SBO Series 1 heater lamp

Fri, 19 Jun 2026 08:23:02 +0800

On the blow molding line, uneven preform heating doesn’t just waste material—it eats straight into your margin. You see it in off-spec bottles, in the scrap pile, and in the way the machine strains to compensate. With the Sidel SBO Series 1, the heater lamp isn’t just another consumable. It’s the control point for the entire heating tunnel. Here’s what matters under the hood. We build the Sidel SBO Series 1 heater lamp as a short-wave infrared emitter, tuned to the machine’s thermal profile. The quartz envelope gives you fast response and stable output across the heating zones. The specs are matched to the OEM geometry—exact lamp length, R7s connector alignment, and the right power density to hit the preform shoulder and body temperature without scorching. In practice, that translates to repeatable heating inside the tight window your blow molder needs for consistent stretch blow molding. And here’s why it holds up on the floor. This lamp is designed for the SBO Series 1 tunnel layout, so you don’t have to gamble with generic replacements. The payoff shows up as more consistent wall thickness, fewer pinholes, and less shift-to-shift variability. Energy use comes down because the lamp hits setpoint quickly and holds it with minimal oscillation. Downtime drops, too—this lamp is built to run long cycles without sudden output loss. A few field notes that save headaches. Installation is straightforward, but the lamp has to sit square in the reflector and align to the original focal line. Even a small offset will throw off heating uniformity. Keep the reflector clean and inspect the terminal block for heat fatigue—those two details will do more for lamp life than any single component upgrade. If you’re running at very high line speeds, double-check that your power supply and cooling air match the lamp’s duty cycle.

Series on Quartz IR Heating Elements

Replacement lamp for Sidel SBO 20 Series 2

Replacing Sidel SBO 20 Series 2 Heaters: The Real Story Behind the Power

Sidel SBO Series 1 heater lamp