Krones heater bulb manufacturer

Tue, 30 Jun 2026 23:22:38 +0800

On a Krones stretch blow molder, the heating tunnel is the heartbeat of the line. If the halogen heater bulbs start to fade, you’ll see it fast—uneven preform temperatures, flash on the bottles, and the line stopping when it can’t hold the profile. We make Krones heater bulbs to the original OEM spec, so the replacement drops in and tracks the machine’s thermal profile without guesswork. What matters technically These bulbs are built from high-purity quartz glass with tungsten-halogen filaments, tuned for short-wave infrared. The wattage, voltage, and base—usually R7s—are matched to the Krones drawings, and the envelope geometry sits right in the reflector. That keeps the heat focused where it needs to be: the preform neck and body, with stable radiant output across the heating zones. The payoff is repeatable crystallinity and wall distribution, cycle after cycle. On a Krones line, the bulbs have to heat fast and even without overshooting. Our units come up to temperature quickly, support stable zone control, and hold output steady over long runs. That means fewer rejects, predictable bottle quality, and less downtime spent swapping lamps. Energy stays in line because the emitter efficiency matches the machine’s original design intent—no extra kW chasing the setpoint. Installation is straightforward, but the reflector condition is critical. If the reflector is pitted or oxidized, it scatters energy and you’ll get hot and cold bands even with a perfectly spec’d bulb. Keep the heating tunnel clean, and verify thermocouple placement; a misread temperature will shorten lamp life. Match the exact wattage and voltage to the holder rating, and don’t mix emitter types across zones. Run a short warm-up calibration after replacement, and you’ll get the repeatable heating your Krones blow molder is built around.

Manufacturer on Quartz IR Heating Elements

Krones heater bulb manufacturer